0

Brake Disc Hardware

Do your pads rattle over rough tarmac, or do they stick in the caliper after a change? Here we have gathered mounting hardware for disc brakes – clips, springs and brackets that keep the pads and caliper correctly in place. For you who change pads or rotors yourself.

What the hardware does

Clips, anti-rattle springs and guide pins are small parts, but they determine whether the pads can move freely and retract from the rotor. Over time, heat, road salt and corrosion can cause springs to lose tension and sliding surfaces to rust. This can lead to rattling, squealing, uneven pad wear or a dragging brake. That is why many choose to replace the parts at the same time as new brake pads or brake rotors.

How to choose the right kit

The kits are typically made for a specific caliper, so fitment depends on car, model year and axle. In this category you will find, for example, DFC Premium Hardware Kit for front or rear axle on cars such as the Audi RS3, Audi R8 and BMW 550i xDrive, as well as Brembo Caliper Mounting Hardware. In particular, check:

  • whether the kit is for the front or rear axle
  • whether it fits the caliper actually fitted to the car – also after a conversion with, for example, a big brake kit
  • the part number against the car's model year and equipment

Installation and maintenance

Clean rust and dirt off the caliper bracket before fitting the new clips so the pads can slide freely. Only use brake grease where the manufacturer specifies, and keep it away from the pad friction surface and the rotor. Check that the guide pins move easily, and tighten all bolts to the vehicle manufacturer's torque specification. This category belongs under disc brakes, where you will also find brands such as R1 Concepts and PowerStop.

Frequently asked questions

Do I need to replace the hardware every time I change brake pads?

It is not always necessary, but it makes sense if the clips are rusty, deformed or have lost tension. Worn parts can cause rattling, uneven wear and pads that stick in the bracket.

Can new clips and springs eliminate brake squeal and rattle?

They can often reduce rattling because the pads are held more steadily. However, squeal can also be caused by the pad material, glazed rotors or lack of cleaning, so the result depends on the specific brake.

Does brake hardware need to be approved for road use?

That depends on the product and the car. The parts are part of the braking system, so check the manufacturer's information and any approval for the specific part number, and make sure the kit fits the car's original or approved caliper.

View as Grid List
Sort by
Display per page

DFC SS Hdwr Kit

dfc340-26002SS
DFC 17-25 Tesla Model Y Rear Stainless Steel Hardware Kit
11,67 € excl. VAT