0

Charging Accessories

How do you get power from a solar panel safely into your car's battery? In this category we bring together solar panels, solar regulators, Anderson cables and mounting brackets – accessories for you who want to supplement the charge from the alternator or keep the battery charged while the engine isn't running.

How panel, regulator and cables work together

A solar panel delivers a voltage that varies with the light, so the current typically needs to pass through a solar regulator before it reaches the battery. The regulator controls the charging so the battery isn't overcharged. From REDARC you'll find, for example, the Solar Regulator w/Anderson Connect in 20 A and 30 A, as well as a value pack with regulator and cable. Anderson connectors provide a quick connection between panel, regulator and battery. These accessories complement the rest of the charging system, but do not replace an alternator or a voltage regulator for the engine.

How to choose the right charging accessories

  • Panel output: 120 W or 180 W. The choice depends on your power consumption, how much sun the panel gets and how much space you have.
  • Regulator current rating: 20 A or 30 A should match the panel's maximum current, ideally with some margin if you want to expand later.
  • Cables: A 16 ft (approx. 4.9 m) cable gives you reach, while a short cable typically means less voltage drop. The 1 ft parallel cable can be used to connect units in parallel – check the intended use for the specific part number.
  • Brackets: Corner, side and spoiler brackets in ABS plastic, the latter in 20.7" and 26.4". Choose based on the panel frame and the mounting surface.

Installation and maintenance

Position the panel so it isn't shaded, and route the cables away from sharp edges. Keep the surface clean, as dirt can reduce output, and regularly check that the connectors are secure. If you need to charge from a wall socket, you'll find battery chargers in the sister category.

Frequently asked questions

Does a solar panel always need a solar regulator?

Typically, yes. The panel's voltage varies with the light, and without regulation the battery can be overcharged. Here you can choose, for example, REDARC solar regulators rated at 20 A or 30 A, which are installed between the panel and the battery.

How do I choose between a 20 A and a 30 A regulator?

It depends on the total current from your panels and whether you want to be able to expand later. The regulator must be able to handle the panel's maximum charging current, so check the values in the datasheet for the specific part numbers.

What should I look out for with Anderson connectors?

The connection must be fully seated, and the connector and cable must match the current rating. Loose or corroded connectors can cause heat and voltage drop, so check them regularly, especially after driving in damp conditions or on gravel.

View as Grid List
Sort by
Display per page