Differential Install Kits
Changing the gear ratio in your axle or fitting a new ring and pinion set? Install kits bring together the bearings, seals and shims that typically need replacing during setup, so you have the parts for e.g. Dana 44, GM 8.6in or Toyota 9.5in ready for your project.
What does an install kit contain?
An install kit bundles the wear parts that are typically replaced when you fit a new ring and pinion set: e.g. pinion and carrier bearings, seals, shims for setting preload and backlash, and a pinion nut. The exact contents depend on the kit, so check the product description. If you only need to renew bearings and seals without changing the gear ratio, a differential rebuild kit may be the relevant choice.
How to choose the right kit
The kit must match your specific axle, not just the car. So check:
- Axle type and ring gear size, e.g. Dana 35, Dana 80, GM 8.5in/8.6in or Toyota 9.5in.
- Position: front or rear axle, and whether the axle is IFS or IRS.
- Differential type – some kits are specified for e.g. an open differential or an ARB locker.
- Model year and variant – the kits for e.g. Ford F-350 are split by model year and axle (Dana 70HD or Dana 80).
In this category you will find kits from e.g. Revolution Gear & Axle and Eaton as well as Ford Racing and COMP Cams. If you are fitting a differential locker at the same time, check whether the kit is intended for that combination. Setting backlash and preload requires measuring tools and experience, and incorrect setup can typically cause noise and increased wear on gears and bearings.
Frequently asked questions
What is the difference between an install kit and a rebuild kit?
An install kit is typically intended for fitting a new ring and pinion set and contains parts for setting backlash and preload. A rebuild kit can also contain bearings and seals, but the contents depend on the product, so compare the descriptions.
Can I reuse the old bearings when changing the gear ratio?
It can be done, but new bearings are typically recommended, because the bearings are pressed off and on during setup, and worn bearings can cause incorrect preload and noise. With an install kit, the entire setup can be done in one go.
Does the differential need breaking in after installation?
Many manufacturers recommend a period of gentle driving and an oil change after the first miles, so new gears and bearings can bed in. Follow the instructions for the specific ring and pinion set, as oil requirements and intervals depend on the product.