0

Hand & Other Tools

Is the primary clutch stuck on the shaft of your ATV, or does a new clutch disc need to be centred before the gearbox is lifted into place? In this category we bring together hand tools and specialty tools for exactly the jobs where ordinary wrenches won't do. It's for you if you work on your own car, ATV or UTV.

Specialty tools and wrenches for the workshop

The category is divided into specialty tools, made for one specific job, and wrenches for general work. Examples include EPI pullers for the primary clutch, e.g. for Polaris RZR, Can-Am Maverick and Kawasaki Brute Force. There is also the ACT Alignment Tool – a clutch alignment tool – which is listed for specific car models such as Honda S2000 and Audi TT Quattro. BikeMaster is also a brand in the category.

How to choose the right tool

Specialty tools are typically matched to a specific model and model year. So check the product name against your vehicle rather than going by appearance. Pay particular attention to:

  • Model and year: The EPI pullers are listed with model year and engine size, e.g. CF Moto CForce 400-1000 from the 2016 model year onwards.
  • Thread and size: The puller must match the thread in the clutch exactly. The wrong size can damage the thread.
  • The job: An alignment tool is typically used to keep the clutch disc centred while the pressure plate is tightened, so the gearbox input shaft can be guided into place.

Use and maintenance

Pull a clutch off with steady, even pressure. Avoid using an impact wrench unless the instructions for the specific tool allow it, as it can damage both the tool and the thread. Make sure the vehicle is stable, e.g. secured with ramps and wheel chocks. Clean the tool after use and store it so the threads and guide surfaces don't get damaged. With storage solutions it's easier to keep track of your model-specific tools. Other workshop equipment can be found under tools and shop equipment.

Frequently asked questions

What is the difference between a clutch puller and an alignment tool?

A puller is used to pull the primary clutch off the shaft on, for example, an ATV or UTV. An alignment tool is typically used during installation, so the clutch disc sits centred when the pressure plate is tightened and the gearbox is fitted.

Can I use the same puller for several models?

It depends on the tool. Some EPI pullers are listed for several models, e.g. Polaris 900 Ranger Crew and 900-1000 RZR. However, the thread and size must match exactly, so always check the product name for your vehicle.

Why is the primary clutch often stuck so tight?

The clutch typically sits on a tapered shaft, where it can seize over time. That's why a puller is often required. If you use a pry bar or similar, you can damage the clutch or the shaft.

What should I check before using the alignment tool?

Check that the tool fits the clutch disc hub and the pilot bearing before you tighten the pressure plate. The tool should slide in easily without play. If the disc sits off-centre, it can be difficult to guide the gearbox into place.

View as Grid List
Sort by
Display per page