Spacers & Shims
Do you need a precise spacer between the pinion bearings, or does a rod end need to work at a greater angle? This category contains spacers for differentials, axles and wipers as well as spacers for rod ends, so you can get bearing preload, geometry and fitment to work out.
Spacers for differentials and axles
A pinion spacer sits between the pinion bearings and helps determine the bearing preload. A crush spacer – a spacer that is compressed when the pinion nut is tightened – deforms during installation, which is why it is typically recommended to use a new one whenever the differential is taken apart. At OMIX you will find, for example, pinion spacers for Dana 44, Dana 35 and AMC 20 as well as a crush spacer for Jeep Liberty and Wrangler. There is also a conversion spacer for the AMC 20 axle and a spacer for the wiper pivot on Jeep CJ. Pinion depth and gear mesh are typically adjusted with shims, so check whether your project requires them too.
How to choose a rod end spacer
At QA1 you will find high misalignment spacers in stainless steel. They sit on each side of the ball in a rod end and give the joint room to work at a greater angle without hitting the bracket. Choose based on several dimensions at once:
- Inside diameter, which must match the bolt diameter.
- Ball width – narrow and standard ball width are not the same.
- Overall width relative to the opening in the bracket.
- Material relative to the environment the part will be used in.
Dimensions are given in inches, so measure your existing parts before you choose.
Installation and accessories
Use the bolt, nut and tightening torque specified by the vehicle or component manufacturer, and check that the spacer sits flat without play. You will find suitable bolts in the sister category, and under spacers the individual spacers are gathered in one place.
Frequently asked questions
Can I reuse a pinion crush spacer?
It is typically not recommended. A crush spacer deforms when the pinion nut is tightened and cannot provide the same bearing preload again afterwards. As a rule, use a new one whenever the pinion is removed.
What is the difference between narrow and standard ball width?
It describes the width of the ball in the rod end the spacer will be fitted to. The spacer must match exactly that ball width and the bolt diameter, otherwise the joint can develop play or sit crooked.
How do I know if a pinion spacer fits my axle?
It depends on the axle type, not just the car. Check whether you have, for example, a Dana 35, Dana 44 or AMC 20, and compare with the product description for the specific part number.
Do rod ends with spacers need approval for inspection?
It depends on the product, the car and where the part is fitted. Modifications to steering or suspension may require approval, so check the specific part number and ask your inspection centre before you install.