0

Valve Locks

What keeps the valve spring and spring retainer in place on the valve stem when the engine revs high? The valve locks do – small wedge-shaped halves that lock into the groove on the stem. These parts are for you if you are building or rebuilding a cylinder head and replacing valves, springs or retainers.

What valve locks do

The valve locks secure the spring retainer to the valve stem and transfer the spring force to the valve. At higher rpm and with stronger valve springs the load increases, and locks that do not fit precisely can cause wear in the groove or, in the worst case, let the retainer come loose. That is why it can make sense to replace the locks together with springs and retainers in a build.

How to choose valve locks

The locks must fit both the valve and the retainer precisely. Check in particular:

  • Stem diameter: The locks must match the valve stem, e.g. 5.5 mm, 6.5 mm or 5/16 inch. Measure or check the specifications of your valves.
  • Grooves: The valve stem can have one or more grooves, and the profile of the locks must match – for example, there are single-groove locks for Subaru EJ205/EJ257.
  • Retainer: The angle of the locks must suit the retainer. Some are made for specific retainers, e.g. Brian Crower locks for BC2100 on Mitsubishi 4G63/Evo or for BC2010 and BC2011 on Honda/Acura.
  • Construction: Billet locks are available, e.g. for Nissan SR20DE/T, Nissan RB26 and Toyota 3SGTE. The right choice depends on the load and the rest of the valvetrain.

Installation and brands

The locks are installed with a valve spring compressor. Make sure both halves sit evenly and fully in the groove before releasing the compressor. In this category you will find brands such as Brian Crower, Ferrea, COMP Cams, Supertech and GSC Power Division. You will find matching parts among valves and in the full camshafts and valvetrain category.

Frequently asked questions

Can I reuse my old valve locks with new spring retainers?

That depends on whether the angle and fit match. New retainers may require locks with a different angle or design. The manufacturer often states which locks fit a given retainer, so check this for the specific part number.

How can I tell whether my valves have one or more grooves?

You can see it on the valve stem once the locks are removed, or in the valve specifications. The locks must match the groove profile of the stem, otherwise they will not seat correctly and can slip.

Should valve locks be replaced every time the cylinder head is rebuilt?

Not necessarily, but the locks should be inspected for wear, marks and deformation. If you replace valves, springs or retainers, or increase rpm and spring force, new locks can be a sensible choice.

View as Grid List
Sort by
Display per page

TITANIUM RETAINERS, SUPER LOCK

cca738-12
COMP Cams Titanium Retainers Super Lock
415,91 € excl. VAT